Search: trailer couplers   >   Demco  x   >  

The DeeMaxx Disc Brake Kit #DE82FR comes with 2 Slip-on rotors, calipers and brackets for one axle. The slip on rotors are for a 6 on 5-1/2" idler hubs and the mounting brackets fit on a 5 bolt brake flange.

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…

Yes, I do have the exact dimensions you need of the Demco Channel Tongue Trailer Coupler part #DM15945. I have attached these for you below.

I do have an option for you but I cannot give you exact bearing numbers for your trailer unless provided with spindle measurements or the trailer's VIN (if the manufacturer is still in business). I can however tell you that the two most common…

The 168255TC oil seal is designed for use on for oil bath hubs, but they can be used on grease hubs. They basically just provide a better seal to hold oil in; they will still work for grease. The springs on your oil seals are required to function…

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

Yes, your 2007 Honda Fit Sport with a manual transmission can be flat towed behind an RV. You'd need to start with a base plate kit like the part #521558-1 which is a confirmed fit. In addition to the base plates, you will also need a compatible…

Yes the coupler part #DM13689-52 that you referenced is lockable. For a pin style lock the part #28012 would work well. Or for a lock that goes around the coupler opening the part #BLTL-20-40D would be a great option. I attached review videos for…

You could install disc brakes on the Timbren Axle-Less Suspension #ASR5200S01. You would use one of the kits from the link I have included to the right. All of these kits have a 6 on 5-1/2 bolt pattern. The kits linked take the same inner bearing but…

The Demco Channel Tongue Trailer Coupler - eZ-Latch #DM15945 is designed for a 3"x3" tube.

I have added a link to a help article for you which has the formula you need that allows you to determine exactly where to position your axles on a trailer. Using this formula, based on measurements you'll need to take and the weight of the…

The overall length of the Demco Channel Tongue Trailer Coupler #DM15945 is 11.042".