Trailer Lights, Connectors, and Wiring

Personally I wouldn't go with Timbren's for your needs. They're essentially rubber bump stops that prevent your suspension from flexing when weights placed on the rear of your Canyon. The major issue with them is comfortability when you…

It's a wire color difference but not a function difference on the pins of the 7-way. The difference comes from the fact that the two different styles are representative of two different areas that uses trailers. Traditional is usually seen on…

The Optronics LED Trailer Tail light - Stop, Tail, Turn - Submersible - 10 Diodes - Red Lens #STL72RB will use the PVC Grommet for 6-1/2" Oval Trailer Tail Lights #A70GB for mounting. With this combination the opening you need to cut is a…

The Buyers Products Trailer Wiring Junction Box #3375601101 referenced in your question measures 6.5 inches long, 3.21 inches wide, and 2.5 inches tall when the cover is installed. The mounting holes at each end are spaced apart 7.38 inches on…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Thanks for reaching out, Sisco! The Tow-Rax Aluminum Storage Cabinet w/ Folding Tray #TWSP30CSA doesn't have a specific mounting kit since enclosed trailers vary greatly by construction. You'll need to either anchor it to wall supports or…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The TecNiq Industrial LED Scene Light #TN43XR has 3/16" diameter mounting holes spaced 16" apart on center (see attached).

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

To install the Tekonsha Prodigy P3 Electric Brake Controller #90195 into your 2014 Chevrolet Express the black wire from the controller will go to 12 volt power, the blue wire runs back to your 7-way trailer connector at the rear of your van, the…

I can tell you were to access the correct brake switch wire to install a brake controller on your 2014 GMC Savana Van. You will need to access the wire behind the BCM (body control module) located behind the dash on the passenger's side of the…